space:lasercutter

This is an old revision of the document!


FabCreator MK5 Lasercutter

Please add yours as soon as you made a good cut!

Material Thickness Supplier Cutting Speed Cutting Power Engraving Speed Engraving Power
MDF 3 mm Coop B+H
Plexiglass 4 mm Obi 10 100

Software Setup

Make sure the Fume Extractor gets activated during cutting!

M555 S230 ; Filter ON should be called whenever laser gets turned on (M3 ; Laser ON). This is usually part of the GCODE START commands. For the GCODE END commands M555 S40 ; Filter idle should be called after laser is turned off and machine was homed.

  • space/lasercutter.1542152611.txt.gz
  • Last modified: 3 years ago
  • by raffael.tschui