Nestbox Version 2 User Manual
Installing the perch and the loggin device
Under Construction
Calibration Procedure
Under construction
Exchanging the SD card
- Open the plastic case of the main nestbox device
- Press the button (marked with “start”) mounted on the internal board and make sure the little light (marked with “data”) turns on during ca. 1 second at least.
Please note that this button resets the internal clock. Therefore, it is important to write down the exact time when you pressed it in order to correspond the local timestamp to the actual time.
- You may afterwards remove the SD card from its slot. (If needed, you may now also exchange the battery.)
- Insert a freshly formatted (FAT32) SD card with a config.txt file stored on it, containting the following lines:
115200,26,0,0,1,0,0 baud,escape,esc#,mode,verb,echo,ignoreRX
If you changed the battery, please press the start button again and write down the time you pressed it.